Instructions for DTF transfer

Applying a DTF transfer to fabric follows a series of precise steps to ensure optimal results.

Fabric preparation :

○ Place the fabric on the heat press. Make sure it is smooth and wrinkle-free.

○ Preheat the fabric for a few seconds to remove any moisture and improve the adhesion of the transfer.

Transferring the pattern :

○ Position the DTF film, printed side against the fabric.

○ Cover the film and fabric with a sheet of baking paper or Teflon sheet to protect the print.

○ Close the heat press and apply the necessary heat and pressure. Typical settings are:

■ Temperature: 160°C ( 320 ° F)

■ Pressure: Medium to high (approximately 18 lbs of pressure)

■ Time: 20 to 30 seconds

Applying DTF transfers with an iron (without steam) can be a little trickier than with a heat press, but it is possible with a few adjustments and tricks.

○ Press the iron firmly onto the Teflon sheet or baking paper.

○ Apply 18 lbs of even pressure and hold for approximately 20-30 seconds.

○ Place the iron on the different parts of the design if necessary, taking care to apply constant pressure and not to move the DTF film during this operation.

○ Allow to cool completely and carefully peel the DTF film off the fabric. The design should now be transferred to the textile.

Final fixing :

○ To ensure the durability of the transfer, press the fabric covered with a Teflon sheet or parchment paper again for 10 to 20 seconds.

Practical advice:

Pre-test : Before transferring to a final product, perform tests on scraps of fabric to adjust the heat press settings (temperature, pressure, time).
Care : DTF transfer textiles should be washed inside out in cold water and you should avoid bleach. Air dry or tumble dry on low heat to maximize the durability of the design.

DTF transfer is a versatile method that, when done correctly, delivers high quality, long lasting results suitable for a wide range of textiles.